Controls And Functions; Front Panel - Yamaha RX-V1300RDS Bedienungsanleitung

Front Panel

1 2
NATURAL SOUND AV RECEIVER RX-V1300RDS
STANDBY
/ON
6CH
SPEAKERS
BASS PROCESSOR
EXTENSION
A B
8 9 0
1
STANDBY/ON
Turns on and sets this unit in the standby mode. When
you turn on this unit, you will hear a click and there will
be a 4 to 5-second delay before this unit can reproduce
sound.
Standby mode
In this mode, this unit consumes a small amount of
power to receive infrared-signals from the remote
control.
2
6CH (INPUT)
Selects the source connected to the 6CH INPUT jacks.
The source selected by pressing 6CH (INPUT) takes
priority over the source selected with INPUT (or the input
selector buttons on the remote control).
3
INPUT selector
Selects the input source you want to listen to or watch.
4
(INPUT) MODE
Sets the priority for the types of input signals (AUTO,
DTS, ANALOG) to receive when one component is
connected to two or more input jacks of this unit (see
page 28). Priority cannot be set when 6CH INPUT is
selected as the input source.
5
Remote control sensor
Receives signals from the remote control.
4
0102V1300_1-9_EN-GB.p65

CONTROLS AND FUNCTIONS

3 4 5
INPUT MODE
PRESET/
A/B/C/D/E
TUNER
DIRECT
STEREO PROGRAM
DSP
EFFECT
q w e r
4
6
D I G I T A L
RDS MODE
PRESET TUNING
TUNING
/TUNING FM/AM MEMORY MODE /FREQ EON
EDIT MAN'L/AUTO FM AUTO/MAN'L MONO
PHONES S VIDEO VIDEO L AUDIO R
SILENT VIDEO AUX
t y
PRESET TUNING
/TUNING FM/AM MEMORY MODE
EDIT MAN'L/AUTO FM AUTO/MAN'L MONO
u i o p a s d f
6
Front panel display
Shows information about the operational status of this
unit.
7
VOLUME
Controls the output level of all audio channels.
This does not affect the REC OUT level.
8
SPEAKERS A/B
Turn on or off the set of main speakers connected to the A
and/or B terminals on the rear panel at each time its
corresponding button is pressed.
9
BASS EXTENSION
Turns on or off the BASS EXTENSION function at each
time the button is pressed, this feature boosts the bass
frequency of the left and right main channels by +6 dB
(60 Hz) while maintaining overall tonal balance. This
boost is useful if you do not use a subwoofer.
0
PROCESSOR DIRECT
Turns on or off the PROCESSOR DIRECT function at
each time the button is pressed. When this is on, BASS,
TREBLE, and BASS EXTENSION are bypassed,
eliminating any alteration of the original signal.
2002.11.07, 12:06
7
VOLUME
BASS TREBLE
PTY SEEK
MODE START
OPTICAL
– + – +
g h
RDS MODE
/FREQ EON PTY SEEK
MODE START