Installation Of The Wall Bracket - Silvercrest SAST 18 A1 Bedienungsanleitung

Installation of the wall bracket

DANGER! ELECTRIC SHOCK!
► Ensure that there are no power cables or water pipes in the wall at the
location where you intend to drill the holes for the wall bracket
Drilling into a current-carrying electric cable can be potentially fatal!
1) Select a suitable installation location for the wall bracket
It must be possible to remove the handheld vacuum cleaner easily and there
must be a mains power socket nearby. In addition, there should be no power
or water lines in the wall.
2) Drill two holes below each other at a distance of approx. 110 mm from each
other. The drill holes must be suitable for 5 mm wall plugs.
3) Push in the wall plugs and screw in the screws so that the heads protrude a
few millimetres.
4) Hang the wall bracket
that the screws slide into the slots. The wall bracket
against the wall. You can adjust the distance to the wall and compensate for
any unevenness in the wall by screwing in or unscrewing the screws.
5) Ensure that the power cable is not trapped and that it lies properly in the
cut-out.
6) Push the two accessories holders
and right of the wall bracket
accessories holders
7) Place the barrel plug
from below. Secure the barrel plug
8) Plug the mains adapter
SAST 18 A1
with the drill holes over the two screws and ensure
into the respective catches on the left
. You can place the nozzles in the
.
of the power adapter
by turning it.
into a power socket.
.
:
should lie flush
into the wall bracket
GB │ IE │
29 ■