Cleaning the brush attachment
To achieve the best results, the motorised brush attachment 6 should be checked
regularly for blockages and any hairs, threads or dirt should be removed .
To simplify cleaning, the brush on the brush attachment 6 can be removed:
1) If you have not already done so, pull the brush attachment 6 out of the
suction opening .
2) Push the release switch on the brush attachment 6 in the direction of the
arrow (as far as the stop) . The brush can now be removed and cleaned . The
release switch automatically springs back into place .
3) To replace the brush after cleaning, proceed as follows:
–
Start by pushing one end of the brush onto the drive shaft on the
opposite side of the release switch . Note that only one side of the brush
fits onto the drive shaft .
–
Push the release switch on the brush attachment 6 in the direction of the
arrow (as far as the stop) and hold it there . Now push the other end of
the brush into the appropriate recess on the side of the release switch .
–
Let go of the release switch to lock the brush in place . The brush should
now be straight and firmly attached to the brush attachment 6 .
Cleaning the appliance
1) Clean the housing and the attachments with a slightly damp cloth .
For stubborn soiling use a mild detergent on the cloth .
2) Dry all parts thoroughly before using the appliance again or storing it .
Storage
Store the appliance in a dust-free and dry location .
SAST 18 A1
GB │ MT
│
55
■