Comet KF series Bedienungsanleitung Und Wartungsanleitung Seite 28

stop the cleaner by turning the master switch (1) to "0" and adjust the head (30) as shown in FIG. 4-b
(these versions deliver the detergent at low pressure).
• Turn the knob (34) until the amount of product required is delivered. After use, rotate the knob (34)
clockwise to the "0" position.
OPERATION WITH WATER SOFTENER (ONLY EXTRA)
versions of the product are not fitted with the water softener option as standard.
"CLASSIC"
A maintenancefree, ion exchanger water softener can be purchased as an optional accessory to be
fitted to the suction unit.
versions of the product are fitted with a high-performance water softener as standard, preventing
"EXTRA"
the build up of lime scale as a result of using the cleaner with hot water.
• Turn the master switch (1) to "0". Unscrew the cap (9) and fill the tank with liquid, making sure it does
not spill over. We recommend using a funnel reserved exclusively for this purpose (maximum tank
capacity 2 L/0.53 US gal). Replace the cap and check the level regularly.
Only use water softeners recommended by the Manufacturer.
• Release the cleaner gun lever (22) to stop the high pressure jet and the high pressure cleaner moves to
by-pass operating mode, and if it remains in this condition it will stop automatically after approximately
13 seconds (Total Stop).
• The cleaner will resume normal operation the as soon as the lever on the gun is pressed.
WARNING
• If you stop the high pressure jet and put the gun down, enable the locking handle (23). STEP S IN FIG. 4.
STOPPING THE CLEANER – TIMED SHUTDOWN MODE (ONLY EXTRA)
• If the cleaner remains in Total Stop mode for more than 15 minutes, it will switch off completely and
the warning light (45) will light up. To resume work, turn the master switch (1) to "0" and wait for a
few seconds before repeating the procedure to start up the cleaner as described in
.
CLEANER"
• Run the cleaner for a few minutes with cold water.
• Close the tap on the water supply off completely (or remove the suction pipe from the draft tank).
• Drain the water out of the cleaner by running it for a few seconds with the cleaner gun lever (22)
pressed.
• Turn the master switch (1) to "0" .
• Take the plug out of the power socket.
• Eliminate any remaining pressure in the high pressure hose (35) by keeping the cleaner gun lever (22)
pressed down for a few seconds.
• Wait for the cleaner to cool down.
• Wind up the high pressure hose (35) with due care, making sure it is not bent. For products without a
hose reel, hang it up on its support (10).
• Wind up the power cord (6) and hang it up on its support (10).
28
STOPPING THE CLEANER – TOTAL STOP MODE
STOPPING
STORAGE
"OPERATING THE