Electrical Connection - Fagor 6HV-585 TCX Betriebsanleitung

EN 2 / INSTALLING YOUR APPLIANCE
Single phase line 220-240 V ~
Differential circuit breaker or
2 pins + e e a a r r t t h h CEI
60083 standard
• • ELECTRICAL CONNECTION
Electrical safety should be ensured by correct
recessed fitting.
maintenance operations, the appliance
should be unplugged from the mains and the
fuses should cut out or removed.
The electrical connection should be made
before the appliance is put in place in the unit.
Check that:
- The mains power is sufficient
- The power cables are in good condition
- The diameter of the wires complies with the
installation regulations.
Your oven should be connected with a
standard 1,5mm2 3 conductor cable (1ph + 1N
+ earth) which should be connected to the
220-240V ~ single phased network by standard
1 phase + 1 neutral + earth CEI 60083 plug
or a double pole cut-out device in accordance
with the installation regulations.
10A fuse
Plug with
Power cable length
approx. 1.50 m
During fitting
20A Single phase meter
220-240V ~ 50Hz
It should be possible to disconnect the
and appliance from the mains, either through the
use of a plug or by fitting a switch to the
stationary conduits in accordance with the
installation regulations.
Warning
The earth wire (green and yellow) is
connected to the
appliance and should be connected to the
earth of the installation.
In the event of connection with a plug, it
should be accessible after installation.
The fuse of the installation should be 10
amps.
If the power cable is damaged, it must be
replaced by the manufacturer, its After-
Sales Service or similarly qualified persons
to avoid danger.
8
terminal of the