Operation And Maintenance; Operational Limits - York Laser Gebrauchs - Und Wartungsanweisungen

(see enclosure 1/A, 1/B, 1/C pos. 7) and make the
electrical connections accordingly to the electric wir-
ing diagram located in the front inner part of the unit
and to the diagram of the controller.
2. Fix the wires to the base of the control panel by us-
ing the given clamps and be sure that the wires under
the panel with the slots are blocked at a distance of at
least 5 mm from the slots themselves.
3. Fix back the cover box to the base with the screw.
4. Pay attention to the fixing and the path of the con-
nection cables, as illustrated in fig. 7.
5. Make sure that the installation doesn't damage the
components and cannot be of any danger to persons,
objects or animals.

7. OPERATION AND MAINTENANCE

7.1 OPERATIONAL LIMITS

• This unit is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible
for their safety.
• Children should be supervised to ensure that they do not play with the unit.
• For installations without a thermostat or room temperature limiting device, it is prohibited to
use the fancoil in small rooms occupied by people unable to leave the room by themselves,
unless they are not under constant surveillance.
Since your fan coil is equipped with a water-fed heat exchanger, be sure that ambient temperature
does not fall below 0 °C, which could cause the formation of ice in the exchanger pipes with
consequent risks of frost damage.If ambient temperature may fall below 0 °C, drain the coil when
ALWAYS GROUND THE UNIT.
EN
1
2
3
4
5
6
7
Fig. 7
8
9
10
+
35