York Laser Gebrauchs - Und Wartungsanweisungen Seite 33

• Vertical models, insert the drain pan hooks into the slots in the unit side and push
downward (Fig. 6).
• Horizontal models, insert the pipe of the drain pan into the hole in the side of the unit;
then fix it with the two supplied screws (Fig. 6a).
• Insert manually the elbow for condensate
discharge, without using any tool and connect
it to the small pipe of the main condensate tray.
In case of operation of the unit in «cooling» mode, YORK recommends to oper-
ate as follows:
• install an electric valve (optional supplied on request), which stops the cold water flow
inside the heat exchanger when the unit is inoperative;
• foresee a suitable water condensate drainage system, duly slanting, and
check the proper downflow;
• execute a proper insulation of valves, pipes and connection fittings of the fancoil to
the system.
IT IS RECOMMENDED TO SIPHON THE CONDENSATE DRAIN
EN
1
2
3
4
5
6
7
8
9
10
+
33