Installing And Assembling; Installation; How To Open The Housing; How To Install The Camera - Videotec Verso Hi-Poe Bedienungsanleitung

6 Installing and
assembling
Only specialised personnel should be
h g
allowed to install and assemble the device.
h g The housing where this device is installed
must be powered by 12Vdc or 24Vac
voltage.
h g Turn off the power before performing any
operations.

6.1 Installation

6.1.1 How to open the housing

To open the housing, loosen the 2 screws on the side,
turn the cover and the upper half of the body about
the opening hinge axis.
Fig. 01
In this way there will be easy access to the inside of
the housing.

6.1.2 How to install the camera

This section describes how to install the camera
inside the housing. It should be remembered that the
power supply can be taken from the circuit supplied
after making sure it is correct one.
Open the housing as described before.
Extract the internal support slide by partially
loosening the fastening screws (01). Move the slide,
by sliding it until the holes coincide with the slide
locking screws (02).
Fasten the camera with the 1/4" screw; if necessary
place the insulating spacer between the camera and
the upper half of the slide (03). If necessary, use the
supplied spacers to correctly position the camera and
optics.
01
Fig. 02
Reposition the internal slide by tightening the
previously loosened screws.

6.1.2.1 RJ45 connection

Fit the gasket (01) to the cable gland M20 (02).
Fasten the cable gland to the bottom of the housing
(03) using the M20 nut (04) with a torque wrench
setting of 7Nm.
Pass the cable with connector RJ45 (05) through the
upper part of M20 cable gland(06).
04
01
03
Fig. 03
Choose the gasket and then put it on the cable.
Fig. 04 Diameter of cable; from 3..5mm a 5.5mm.
Fig. 05 Diameter of cable: from 5.5 to 7.5 mm.
03
02
02
05 06
5