After Initial Use; Replacing The Saw Blade; Adjusting/Replacing The Blade Guard; Cleaning And Storage - Parkside PDKS 6.3 A1 Bedienungs- Und Sicherheitshinweise

After finishing the task, release the trigger
stop the saw from running.

After initial use

Once the task has been finished the device must be
disconnected from the compressed air connection.
This first requires the pressure to be completely re-
leased from the lines.
Briefly activate the trigger
release any remaining compressed air.

Replacing the saw blade

Immediately replace the saw blade
or defective.
Always be sure the compressed air supply is dis-
connected when replacing the saw blade
First open the front cover
(see Fig. F).
Use the included socket head wrench
loosen the socket head screws on the saw blade
holder (see Fig. G) and remove the saw blade.
Then insert the new saw blade
blade holder and tighten the socket head screws
again.
Ensure the saw blade
the saw blade holder and cannot be pulled out.
Then close the cover
Adjusting/replacing the blade
guard
To adjust the blade guard
outside screws (see Fig. H) with the included
2 mm hexagon socket wrench
ing the screws you will be able to pull on the
blade guard to adjust it (see Fig. I).
You will now be able to adjust or replace the
blade guard.
Start-up / After initial use / Cleaning and storage
to
4
on the device to
4
if dull, warped
1
!
1
with a screwdriver
7
to
2
into the saw
1
is correctly seated in
1
with the screwdriver.
7
, loosen the two
8
. After loosen-
3
After replacing or adjusting the blade guard,
tighten the previously loosened screws with the
hexagon socket wrench.

Cleaning and storage

To ensure a long life and trouble-free operation, it's
important to observe the following instructions.
Always disconnect the tool from the compressed
air supply before cleaning.
Clean your tool with a dry, soft cloth or lightly
blow it out with compressed air. Never use
caustic cleaners.

Lubricating the air saw

Note: Regular lubrication is required
to ensure the longest possible life to
air tools.
Turn the tool over so the air connection is facing
up and add a few drops of air tool oil or SAE
10–20 engine oil to the tool's air connection.
Activate the trigger
4
perse better.
Hold a rag or absorbent paper towel in front
of the exhaust opening and run the tool on idle
for a few seconds.
ATTENTION! Remove the compressed
air connection before performing main-
tenance!
Excess oil will be blown out.
Keep persons or objects away from the discharge.

Storing the air saw

Store the air tool in a dry location, protected from
the weather and out of the reach of children.
Be sure moisture does not enter the inside of
the air tool.
to allow the oil to dis-
GB/IE 23