Using The Gauge; Getting Started; Fitting The Batteries - Elcometer 204 Gebrauchsanleitung

3 USING THE GAUGE

a Power: Batteries or USB
including battery life indicator
b Measurement Mode
c Reading Stability Indicator
d Measurement Units
e Menu Softkey
f Display Softkey
g Save Reading Softkey
h Reading Value
i Statistics

4 GETTING STARTED

4.1 FITTING THE BATTERIES

Each gauge is supplied with 2 x AA alkaline
batteries.
To insert or replace the batteries:
1 Lift the latch on the battery compartment
cover and rotate anti-clockwise to remove
the cover.
2 Insert 2 batteries taking care to ensure
correct polarity.
3 Refit the cover and rotate the latch clockwise to close.
The battery condition is indicated by a symbol in the top right of the
display ( ):
Full symbol (orange) = batteries at full capacity

Empty symbol (red, flashing) = batteries at lowest

sustainable level
4.2 CONNECTING A TRANSDUCER
1 Align the red dot on the transducer
plug with the red dot on the base
of the gauge.
2 Push the transducer into the
gauge, ensuring that the connector
is fully engaged.
en-3
R
-
- P-E: Pulsed Echo
- mm, Inch
i
h
g
www.elcometer.com
a
b
c
d
e
f
+
+