B) Function "Motion Detection - Renkforce 1243795 Bedienungsanleitung

"Start Time"
"End Time"
• Save the selection with the button "OK" (8); then you will leave setting mode again. Cancel as usual with
the "MENU" (5) button.
Delete time window
• Select one of the time windows set up by you with the control buttons "S" or "F" (9); it is highlighted in
colour.
• Briefly push the "AV" (7) button to delete the selected time window.

b) Function "Motion Detection"

The screen/DVR records the camera image only when a motion is recognised in the recording area. The
sensitivity of motion detection can be set in 3 stages.
• After calling the function, you can separately activate the recording/motion detection for each of the four
possible radio cameras (one is enclosed, up to three more can be ordered as accessories).
• Select the desired radio camera (channel) with the control buttons "S" or "F" (9); it is highlighted in
colour.
• Briefly push the "OK" (8) button to open the setting menu.
• Use the control buttons "S" or "F" (9) to switch between the different setting options and to change the
values with the control buttons "G" or "►" (9).
"Sensitivity"
"Motion Detection"
"Stop Condition"
"Area Setting"
62
Time for recording start (hours/minutes)
Time for recording end (hours/minutes)
Set the sensitivity of motion detection ("High", "Medium", "Low").
The higher the sensitivity is set, the smaller changes in the camera screen will
be sufficient to start the recording.
With the motion detection switched on ("On"), the screen/DVR records the
camera image when changes are found in the camera image (e.g. if a person
enters the recording area).
To switch off the motion detection, set "Off".
Set the time here (8....120 seconds) for which the recording will continue after
no motion is detected in the recording area anymore.
Here, you can choose the area of the camera image to be used for motion de-
tection.
When the setting option "Area ►" is chosen, push the button "OK" (8) to start
selection of the monitoring area.
Move a star icon (*) with the four control buttons "S", "F", "G"and "►" (9).
Push the "OK" (8) button to switch the area on or off.
If the area is on, a "V" appears in the LC display. This area is then used for mo-
tion detection.
Use the "MENU" (5) button to save the setting.