E) Function "Display Items; F) Function "Tv System; G) Function "System Information - Renkforce 1243795 Bedienungsanleitung

e) Function "Display Items"

The display of the screen/DVR can show various information, e.g. the channel number. Since these small
figures may cover important details in the image, they can be switched on and off separately.
This way, you can specify whether you want to see the information or not.
• After calling the function, use the control buttons "S" or "F" (9) to choose between the respective icons.
• Use the button "OK" (8) to switch the display of the respective icon on or off (a small check mark is dis-
played when the display is on).
"RSSI"
"SD/USB status"
"Camera"
"Battery"
• To leave setting mode, push the button "MENU" (5).

f) Function "TV System"

Here, the TV standard (PAL or NTSC) is used for the AV output can be set.
• After calling the function, use the control buttons "S" or "F" (9) to choose between "PAL" or "NTSC".
• Save the selection with the button "OK" (8); then you will leave setting mode again.
To leave setting mode without saving the settings (cancel), push the button "MENU" (5).

g) Function "System Information"

• After calling the function, the screen/DVR shows the firmware version and other information.
• Use the "OK" (8) button or the "MENU" (5) button to leave display mode again.
Display of the signal strength of the radio signal of the radio camera
(Icon " ")
Display of which data carrier is connected/used
(USB = Symbol "
Channel number
(Icon "
Charge condition of the internal rechargeable battery
(Icon " ")
", memory card = Symbol "
")
")
57