Basic Functions; Switching On/Off; B) Calling/Leaving Osd Menu; C) Activate/Deactivate Av Output - Renkforce 1243795 Bedienungsanleitung

9. Basic Functions

a) Switching On/Off
Briefly push the button "
the screen/DVR switched on, the small red LED to the left of the button "
The radio camera cannot be switched on or off. It works permanently if the power is connected.
After switching on, the image of the enclosed radio camera is to appear after a few seconds;
When the signal of a radio camera is received, the LED (4) will light up in green or orange. If this is not the
case, observe chapter 16.
LED is lit green: The signal of a radio camera is received
LED is lit red: The battery is being charged
LED is lit orange: The signal of a radio camera is received and the rechargeable battery is loaded.

b) Calling/Leaving OSD Menu

Briefly push the "MENU" button (5). Then the main menu is displayed.
To leave the OSD menu, also briefly push the button "MENU" (5) (several times if required, if the screen/
DVR is in a submenu.
c) Activating/Deactivating AV Output
Use the button "AV" (7) to switch between playback of the AV-signal on the screen/DVR and the AV-output.
If the AV-output is activated, the screen/DVR LC-display goes out. Concurrent display on the LC
display and the AV output is not permitted.
Connect the AV output (14) to an analogue AV input of a screen or TV via the enclosed AV cable.
52
" (3) on the screen/DVR for 2 seconds to switch the screen/DVR on or off. With
" lights up.