K) Function "Load Default; L) Function "Brightness; M) Function "Volume; N) Function "Alarm Volume - Renkforce 1243795 Bedienungsanleitung

k) Function "Load Default"

With this, you can reset all settings in the screen/DVR to the factory settings.
• After calling the function, use the control buttons "S" or "F" (9) to choose between "Cancel" or "OK"
(restore factory settings).
• Accept the selection with "OK" (8).
To leave setting mode without saving the settings (cancel), push the button "MENU" (5).

l) Function "Brightness"

To adjust the backlighting of the LC display to the ambience conditions, the brightness can be set in several
steps.
• After the function is called, the brightness can be changed with the control buttons "G" or "►" (9).
• Save the selection with the button "OK" (8); then you will leave setting mode again.
To leave setting mode without saving the settings (cancel), push the button "MENU" (5).

m) Function "Volume"

The radio camera used does not have any microphone; therefore, setting of the on the screen/DVR is irrel-
evant. If the volume is set higher, there may, however, be a slight hum in the installed speakers. Therefore,
adjust the volume to the lowest position.
• After the function is called, the volume can be changed with the control buttons "G" or "►" (9).
• Save the selection with the button "OK" (8); then you will leave setting mode again.
To leave setting mode without saving the settings (cancel), push the button "MENU" (5).

n) Function "Alarm Volume"

The setting applies to the volume of the alarm tone when the motion alarm is activated and there is a motion
in the recording area.
This setting is independent from the function "Volume" (see chapter 11. m).
If muting (see chapter 11. j) is active, the alarm sound is muted as well.
• After the function is called, the alarm tone volume can be changed with the control buttons "G" or "►"
(9).
• Save the selection with the button "OK" (8); then you will leave setting mode again.
To leave setting mode without saving the settings (cancel), push the button "MENU" (5).
59