Commissioning; A) Screen/Dvr - Renkforce 1243795 Bedienungsanleitung

8. Commissioning

a) Screen/DVR

• If there is protective foil on the LC display (2), remove it now.
• Now take the larger of the two enclosed plug-in mains adapters (output voltage 5 V/DC, output current
3 A).
Connect the low-voltage round plug the plug-in mains adapter to the corresponding socket (15) of the
screen/DVR.
Plug the plug-in mains adapter into a proper mains socket of the public mains.
• Fold open the setup base (10) on the back of the screen/DVR and put the screen/DVR onto a stable, level
and sufficiently large area. Protect expensive furniture surfaces from impressions or scratches with
suitable pads.
• To save the video recordings, you can either use a microSD/microSDHC memory card (max. 32 GByte) or
a USB data carrier (USB drive or USB hard disc, max. 1 TB).
In the OSD menu of the screen/DVR, the respective memory type used must be set; see chapter
11. d).
The memory card or the USB data carrier should be empty (or there still must be enough memory
left). The only file format permitted is FAT/FAT 32 (no NTFS). If necessary, the memory card or the
USB data carrier can be reformatted; all present data will be lost.
When using a microSD/microSDHC memory card, ensure that it corres-
ponds at least to type "Class 4" (or higher). This marks a writing speed of at
least 4 MByte/s and is absolutely necessary for proper function when re-
cording surveillance videos.
A change of the memory card or the USB data carrier in current operation of the screen/DVRs
is not possible. Before connecting or disconnecting the memory card or a USB data carrier, the
screen/DVR must be switched off.
See also chapter 9. a).
A microSD/microSDHC memory card is pushed into the insert (12) on the right; a USB data carrier must
be connected to the USB socket (11).
If you want to use an external hard disc without a mains unit of its own (e.g. a 6.35 cm/
2.5" hard disc), observe that the screen/DVR is in this case always operated via the plug-in mains
adapter. Because of the high power input of an external hard disc, it is not possible to operate the
screen/DVR via the installed li-ion battery.
If the screen/DVR is to be operated via the li-ion battery, insert a microSD/microSDHC memory
card or connect a USB drive.
49