Changing The Cutting Attachments; Changing The Comb Attachments - Silvercrest SHBS 3.7 A1 Bedienungsanleitung

BB.5$ B%ERRN 6HLWH  'LHQVWDJ  'H]HPEHU    

6.1 Changing the cutting attachments

WARNING! Risk of injury!
Switch off the hair and beard trimmer|5, before you attach or
remove the attachments.
• Figure A: to remove the attachments|12,|3,|4,|11,|13
use your thumbs to press the attachment towards the rear
of the hair and beard trimmer|5.
• Figure B: to attach the attachments, put the lower flap of
the attachment|12,|3,|4,|11,|13 into the slot in the hair
and beard trimmer|5 and press the upper part of the at-
tachment against the hair and beard trimmer until it audi-
bly locks into place and sits firmly in position.

6.2 Changing the comb attachments

Pushing on
• To attach the comb attachments|2 +|1 carefully slide the
appropriate comb attachment over the hair or beard trim-
mer attachment|12 /|13. Press the lower part of the comb
attachments|2 firmly until they lock into place.
Removing
• To remove the comb attachments|2 loosen the comb at-
tachment at its lower end and pull it off the hair and beard
trimmer|5.
• Slide the comb attachment|1 for the beard trimmer attach-
ment|13 upwards from the hair and beard trimmer|5.
GB 11