Troubleshooting - Silvercrest SDBS 2400 B2 Bedienungsanleitung

Troubleshooting

Fault
The appliance is
not working .
The appliance
produces no/too
little steam .
Water drips out
of the sole of the
iron 6 .
Wet patches occur
on the items being
ironed .
NOTE
► If you are unable to resolve the problem by taking any of the aforementioned steps,
please contact the service department .
SDBS 2400 B2
Possible cause
Fault with the power supply .
The appliance is not switched on . Set the On/Off switch w to
There is not enough water in the
water tank 0 .
The appliance is not sufficiently
hot .
The temperature control 4 has
been set in the
range .
The steam unit has not been used
for a long time or is being used
for the first time .
If steam ironing is paused briefly,
the cooling steam condenses in
the connecting hose 2 .
This can lead to drips .
The set temperature is too low for
steam ironing .
Such areas can be caused by
steam condensing on the ironing
board .
Remedy
Check whether the mains plug
is firmly in the mains socket .
the position "1" to switch the
appliance on .
Fill the water tank with water 0 .
Wait until the temperature
indicator lamp goes out .
Set a temperature suitable for
steam ironing (setting range
–
Hold the steam button 5 down a
little longer . The steam takes a little
time until it comes out of the sole of
the iron 6 .
This is normal . Hold the iron over
a collecting cloth or container
and press the steam button 5 .
Steam will discharge from the
sole of the iron 6 instead of
water after a few seconds .
Then you can continue ironing .
Set a temperature suitable for
steam ironing (setting range
Wipe the wetness from the
ironing board and iron the wet
patches dry (without steam) .
GB │ IE │ NI │ CY
) .
) .
│ 17 ■