Steam Ironing - Silvercrest SDBS 2400 B2 Bedienungsanleitung

Steam ironing

♦ Fill the water tank 0 with water if necessary .
♦ Insert the plug into a mains power socket .
♦ Set the On/Off switch w to the position "1" to switch the appliance on . The
integrated control lamp in the On/Off switch w and the heat-up indicator
lamp 3 light up, the "MAX" button z flashes .
♦ Turn the temperature control 4 to set the required ironing temperature . The
temperature control 4 must be set within the
♦ The heat-up indicator lamp 3 lights up during heating . As soon as the set
temperature has been reached, the heat-up indicator lamp 3 goes out .
♦ Adjust the steam power:
–
Press the "MAX" button z to create maximum steam .
–
Press the "ECO" button t to make the appliance produce less steam .
♦ As soon as the "MAX" z or "ECO" button t lights up continuously
(depending on the setting), you can start steam ironing .
♦ While you are ironing, you can now press and hold the steam button 5 to
continuously spray steam onto the items being ironed from the sole of the
iron 6 . Release the steam button 5 to stop producing steam .
NOTE
When you press the steam button 5, it can take a few seconds until steam
comes out of the sole of the iron 6 .
♦ Put the iron down on the stand 7 on the base station q after ironing .
Set the temperature control 4 to "min" .
♦ Set the On/Off switch w to the position "0" to switch the appliance off . The
integrated control lamp in the On/Off switch w and the steam control lamp
"MAX" z or "ECO" t go out .
♦ Pull the plug out of the mains socket .
SDBS 2400 B2
range to produce steam .
GB │ IE │ NI │ CY │ 13 ■