Troubleshooting - Silvercrest SDBSB 3000 A1 Bedienungsanleitung

Troubleshooting

Fault
The appliance is
not working.
The appliance
produces no/too
little steam.
Water drips out of
8
the soleplate .
Wet patches occur
on the items being
ironed.
NOTE
► If you are unable to resolve the problem by taking any of the above-men-
tioned steps, please contact the service department (see section Service).
■ 20 │ GB │ IE
Possible cause
Fault with the power supply.
The appliance is not switched on. Switch on the appliance using
There is not enough water in the
0
water tank .
The appliance is not sufficiently
hot.
The temperature control
to
in the range .
The steam unit has not been used
for a long time or is being used
for the first time.
Steam generation is impaired
by limescale deposits in the
appliance (steam chamber/sole-
8
plate ).
If steam ironing is paused briefly,
the cooling steam condenses in
5
the connecting hose
lead to drips.
The set temperature is too low for
steam ironing.
Such areas can be caused by
steam condensing on the ironing
board.
Remedy
Check whether the plug is firmly
inserted into the power socket.
the On/Off button
Fill the water tank with water
Wait until the heat-up indicator
1
lamp goes out.
3
Set a temperature suitable for
is set
steam ironing
(setting range
Hold the steam button
a little longer. The steam takes a
little time until it comes out of the
sole of the iron
Descale the appliance (see sec-
tion Descaling the appliance/
Descaling the soleplate).
This is normal. Hold the iron over
a collecting cloth or container
. This can and press the steam button
Steam will discharge from the
sole of the iron
water after a few seconds. Then
you can continue ironing.
Set a temperature suitable
for steam ironing
(setting range
Wipe the wetness from the
ironing board and iron the wet
patches dry (without steam).
e
.
0
.
).
2
down
8
.
2
.
8
instead of
).
SDBSB 3000 A1