♦
Push the water tank 0 back into the base station q until it clicks into place .
♦
Set the On/Off switch w to the position "1" to switch the appliance on .
♦
Press the "Anti calc" button u . The "Anti calc" button u goes out .
You have now completed replacement of the limescale filter e .
NOTE
►
After replacing the limescale filter e, it takes about 90 seconds until steam
starts coming out of the sole of the iron 6 again the next time you use the
appliance .
NOTES
Note the following when handling the limescale filter e:
Not suitable for consumption/drinking!
Keep the limescale filter e out of the reach of children .
Store the spare limescale filter in a cool, dry location .
If the appliance is used regularly, it is advisable to always have a replacement
limescale filter available . This means that you can replace the limescale filter
e immediately as soon as the "Anti calc" button u lights up .
You can order new limescale filters e from our service department (see
section Ordering replacement parts) .
Cleaning the appliance
♦
Remove the power plug from the mains power socket if the appliance is
plugged in .
♦
If necessary, allow the appliance to cool down before cleaning it .
♦
Clean the surfaces of the iron and the base station q with a soft, damp
cloth only .
♦
Clean the sole of the iron 6 with a soft, damp cloth . Ensure that the sole of
the iron 6 is not scratched .
♦
Pour out the residual water in the water tank 0:
–
Pull the water tank 0 out of the base station q and tip the remaining
water into the wash basin .
–
Push the water tank 0 back into the base station q until it clicks into
place .
♦
The appliance must be completely dry before further use .
■
16
│
GB │ IE │ NI │ CY
SDBS 2400 B2