Cleaning And Maintenance; Self-Cleaning Function; Replacing The Limescale Filter - Silvercrest SDBS 2400 B2 Bedienungsanleitung

Cleaning and maintenance

WARNING!
Risk of injury!
► Before cleaning the appliance, disconnect the plug from the mains power
socket!
► Allow the appliance to cool down completely if necessary .
► Never immerse the appliance in water to clean it .
CAUTION
Damage to the appliance!
► To avoid irreparable damage to the appliance, ensure that no moisture can
penetrate the appliance during cleaning .
► Do not use aggressive scouring cleaners or solvents, or a wire brush or
other abrasive objects to clean the surfaces .

Self-cleaning function

♦ Fill the water tank 0 with water if necessary .
♦ If the appliance is switched on, set the temperature control 4 to "MAX" and
wait until the appliance has heated up .
♦ Hold the iron horizontally over a suitable container or sink .
♦ Press the "Self clean" button i for about 5 seconds . The self-cleaning
process starts and the "Self clean" button i flashes . Steam flows from
the steam exit holes in the sole of the iron 6 . Any impurities that may be
present are flushed out .
♦ As soon as the self-cleaning process is complete (after about 80 seconds),
the "Self clean" button i stops flashing .

Replacing the limescale filter

After pressing the steam button 5 for a total of around 11 hours, it is time to
replace the limescale filter e .
The appliance will notify you when the time comes: As soon as the "Anti calc"
button u flashes, you need to change the limescale filter e .
Proceed as follows:
♦ Set the On/Off switch w to the position "0" to switch the appliance off .
♦ Pull the water tank 0 by the grip 9 out of the base station q .
♦ Pull the limescale filter e upwards out of the limescale filter shaft .
♦ Place the new limescale filter e in the limescale filter shaft and press it
down until it is firmly in place .
SDBS 2400 B2 GB │ IE │ NI │ CY │ 15 ■