Nidec Unidrive M400 Schritt-Für-Schritt-Anleitung Seite 10

Status
Mode
Parameter
View Mode
Table 11-1 Status indications
String
The drive is inhibited and cannot be run. The Drive Enable signal is not applied to
Inhibit
the drive enable terminal or is set to 0.
The drive is ready to run. The drive enable is active, but the drive inverter is not
Ready
active because the final drive run is not active
Stop The drive is stopped / holding zero speed.
Supply Loss Supply loss condition has been detected
dc Injection The drive is applying dc injection braking
The drive has tripped and no longer controlling the motor. The trip code appears on
Trip
the display.
Under
The drive is in the under voltage state.
Voltage
10
To enter Parameter View mode,
press button or
To select parameter press
To enter Edit Mode,
button
press
(Character to be edited in
Edit Mode
lower line of display flashing)
Change parameter values by pressing
Description
Timeout
To return to status mode,
or press
Press
button
When returning
to Parameter
View Mode
use the
buttons to
select another
parameter to
change if
required
To return to Parameter View Mode,
Press
button to keep the new value
Press button to ignore new value
return the parameter to the pre-editied value
buttons
Unidrive M400 Step By Step Guide
Timeout
button
Drive output
stage
Disabled
Disabled
Enabled
Enabled
Enabled
Disabled
Disabled
Issue Number: 2