Herunterladen Inhalt Inhalt Diese Seite drucken

Remote Control; Start-Up Of The Device/Introduction; Inserting The Batteries - Clatronic mc 1032 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4

Remote Control

1
STOP button
2 SKIP-/SKIP+ buttons
(reverse search/forward search)
3 PROG button
4 REPEAT button (repeat)
5 PLAY/PAUSE button (Play/Pause)

Start-up of the device/Introduction

NOTE:
Some keys are to be found both on the device itself and on
the remote control. Keys with the same designation have the
same function.
Read the operating instructions thoroughly before the start-up!
Select an appropriate location for the device, e.g. a dry, fl at,
non-slip surface on which the device can be easily operated.
Make sure that the device is adequately ventilated!
Connect the loudspeakers to the back of the music centre to
the sockets market „Speaker RIGHT and LEFT".
Insert the plug into a properly installed 230 V, 50 Hz power
socket. Please ensure that the mains voltage corresponds to
the information on the type plate.
The POWER (1) control lamp shows the function.
NOTE:
The lithium cell in the battery compartment of the remote cont-
rol has been secured for transport with a foil. This prolongs the
lifetime of the battery. Before initial use please remove this foil
so that the remote control is ready for operation.

Inserting the Batteries

The battery of the remote control is a long-life lithium cell. If
the range of the remote control is reduced during use, please
proceed as follows:
Open the battery compartment on the back of the remote
control.
Replace the cell by a battery of the same type (CR 2025).
Ensure correct polarity.
Then close the battery lid.
If the remote control is not used for a prolonged period, remove
the batteries in order to prevent battery acid leaking.
CAUTION:
Batteries are not to be disposed of together with domestic
wastes. Dispose of the used batteries at the relevant collection
bin or at your dealer's.
WARNING:
Do not expose the batteries to high temperatures or direct
sunlight. Never throw batteries into the fi re. There is a danger
of explosion!
30
05-MC 1032 CD.indd 30
05-MC 1032 CD.indd 30
NOTES ON HANDLING BATTERIES
Keep batteries away from children. They are not a toy!
Never throw batteries into a fi re or immerse in water.
When inserting a battery, ensure the correct polarity.
Do not open the batteries by force.
Avoid contact with metallic objects. (Rings, nails, screws
et cetera.) There is a danger of short-circuiting!
As a result of a short-circuit batteries may heat up consi-
derably or even catch fi re. This may result in burns.
For your own safety the battery poles should be covered
with adhesive strips during transport.
If a battery leaks do not rub the liquid into your eyes or
mucous membranes. If hands come into contact with the
liquid they should be washed thoroughly and eyes rinsed
out with clear water; if symptoms persist please consult a
doctor.
Germany:
As a consumer you are required by law to return used
(rechargeable) batteries.
You can return your old (rechargeable) batteries free of
charge where they were bought, as well as at the local
public collection points in your town.
These symbols are to be found on coin cells containing harmful
substances:
PR = zinc-air battery
LR = alkaline battery
SR = silver oxide battery
CR = lithium battery
CD deck transport protection
Please open the CD compartment by pressing the
OPEN/CLOSE (open/close) button (5).
Remove the transport protection from the CD player if
present before use.
Headphone Socket (20)
Please use headphones with a 3.5 mm stereo jack plug; these
should be inserted into the socket. The loudspeakers are then
switched off.
BBS switch (22)
This is used to amplify the bass sounds. The switch can be in
one of two positions,
= on,
Volume
The desired volume can be sent using the VOLUME MIN/MAX
regulator (11).
POWER (24)
Turn the device on or off. The POWER (1) control lamp shows
the function.
= off.
20.11.2007 14:49:48 Uhr
20.11.2007 14:49:48 Uhr

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis