Storage; Transport; Disposal And Recycling; Troubleshooting - Scheppach SG2000 Bedienungsanleitung

10. Storage

1. Perform all general maintenance, which are in the
User's Guide in the Maintenance section.
2. Let the fuel out of the tank (Use a commercially
plastic fuel pump from the hardware store).
3. After the fuel is drained, start the machine.
4. Let the machine in idle speed running until it
stops. That cleans the carburetor from the re-
maining fuel.
5. Let the machine cool down. (about 5 minutes)
6. Remove the spark plug.
7. Fill a small amount of 2-stroke engine oil into the
firing chamber. Pull out several times the starter
cord gently to wet the internal components with
the oil.
8. Replace the spark plug.
9. Clean the outer casing of the machine.
10. Keep the machine on a cold, dry place out of reach
of ignition sources and flammable substances.
Recommissioning
1. Remove the spark plug.
2. Pull the starter rope out several times. It cleans
the firing chamber of oil residues.
3. Clean the spark plug contacts or install a new
spark plug.
4. Fill the tank.

11. Transport

m WARNING
Let the engine cool down before transporting the ma-
chine or storing indoors to avoid burns or fire hazards.
If you want to transport the unit empty the fuel tank
before. Clean the unit with a brush or a broom of
coarse dirt.

13. Troubleshooting

Fault
Engine does not start
Generator has too little or no
voltage
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible cause
dirty spark plug
no fuel
Controller or capacitor defective
Air filter dirty

12. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author-
ised collecting point for the recycling of waste elec-
trical and electronic equipment. Improper handling
of waste equipment may have negative consequenc-
es for the environment and human health due to po-
tentially hazardous substances that are often con-
tained in electrical and electronic equipment. By
properly disposing of this product, you are also con-
tributing to the effective use of natural resources.
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body
for the disposal of waste electrical and electronic
equipment or your waste disposal company.
Remedy
Clean the spark plug, or replace.
Electrode spacing 0,6 mm
Refill fuel
Contact your dealer
Clean or replace the filter
GB | 27