Timer Operation; Manual Operation - EuroLite N-130 Bedienungsanleitung

Menu structure
Mode
Warming up phase
Home screen
Operation settings
DMX settings
Fluid sensor
Timer mode makes it possible to manually configure the fog output volume between 1% and 100%, as well as the
output duration and the interval at which the output is to begin. Use the MENU button to select the "Timer Out",
"Duration Set", and "Interval Set" menu items, and set the desired value using ▼ and ▲ respectively. After
finishing the above setting, go back to the home screen by pressing the ENTER button.
MENU Interval Set
▼ and ▲
To activate Timer Mode, press the ▲ / TIMER key below the display. To deactivate Timer Mode, press ENTER /
STOP.
To operate the machine in Manual Mode, confure the the fog output volume between 1% and 100%. Select the
"Volume Out" menu option with the MENU button and set the desired value using ▼ and ▲. Then go back to the
home screen by pressing the ENTER button.
Volume Out
MENU
▼ and ▲
To activate Manual Mode, press the ▼ / VOLUME key below the display. To deactivate Manual Mode, press
ENTER / STOP.
Note
• In manual mode, the machine emits fog continuously until a re-heat is needed.
Display
Warming Up
Ready To Fog
Interval Set 1-200s
Duration Set 1-200s
Timer Out 1-100%
Volume Out 1-100%
Display on/off
DMX512
001-512
Address
Fluid Sensor on/off

TIMER OPERATION

/ Duration Set
1-200S

MANUAL OPERATION

1-100%
Function
The machine is warming up and not ready for use before
the required operating temperature has been reached
The warming up phase has been completed and the
device is now ready for use. Press ENTER button to return
to home screen anytime (except when in DMX mode)
Adjust time interval under timer mode
Adjust duration under timer mode
Adjust fog output volume under timer mode
Adjust fog output volume under manual mode
Activate/deactivate display energy-saving mode after
1 minute of inactivity
Set DMX starting address
Activate/deactivate fluid sensor
/
▼ and ▲
1-200S
19 • EN
Timer Out
▼ and ▲
1-100%