Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Overhead installation
Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure that the
device is installed securely and cannot fall down. The installation must be carried out by a specialist
who is familiar with the hazards and the relevant regulations.
The device may be fastened to a truss or similar rigging structure. The device must never be fixed swinging freely
in the room.
1
The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2
Block access below the work area and work from a stable platform when installing the device.
3
Use rigging hardware that is compatible with the structure and capable of bearing the weight of the device.
Please refer to the "Accessories" section for a list of suitable rigging hardware.
4
Secure the device with a safety bond or other secondary attachment. This secondary safety attachment must
be sufficiently dimensioned in accordance with the latest industrial safety regulations and constructed in a way
that no part of the installation can fall down if the main attachment fails. An appropriate eyelet is mounted on
the device for fixation of the safety rope. Fasten the safety rope in such a way that, in the event of a fall, the
maximum drop distance of the device will not exceed 20 cm.
5
To align the device, release the fixation screws at the mounting bracket, adjust the desired inclination angle
and tighten the fixation screws.
6
After installation, the device requires inspections periodically to prevent the possibility of corrosion,
deformation and looseness.
Operating conditions
Prior to transportation, allow the machine to cool down and completely empty the tank.
Never operate the fog machine without fog fluid. Fire hazard due to overheating! Besides, the unit may
be damaged.
During operation smoke emission may stop. In this case the device is heating up again. After a short
period, the machine will be ready to emit fog again. This process guarantees an appropriate
vaporization temperature and the best fog emission possible. The temperature is regulated by a high-
quality thermostat.
The cable remote provided allows operating the machine in three modes (manual mode, continuous mode and
timer mode). With the wireless remote control it is possible to activate the fog output via radio over a distance of
25 meters. Alternatively, the machine can be controlled with a DMX controller. DMX control will take priority over
remote control operation. The control panel allows the user to adjust the DMX starting address, wireless remote
control and fluid sensor.
Switching on/off
• Prior to switching on, check the fluid level of the tank and fill up fog fluid, if required.
• Connect the machine to the mains with the power plug.
• Switch on the machine with the power switch. The display flashes and indicates "HEAT". At the same time, the
machine starts the warm-up process.
• While the machine is warming up, fog output will not be possible yet. Program the necessary menu settings with
the control panel. Once the warm-up process is completed, the display indicates the standard screen and fog
output will be possible.
• After operation, switch off the machine with the power switch.
WARNING!
OPERATION
CAUTION!
20 • EN
Werbung
Inhaltsverzeichnis
