Operating Elements And Connections; Setup; Filling Up Fog Fluid; Placing The Unit - EuroLite N-130 Bedienungsanleitung

Filling up fog fluid

Fluid handling
Always disconnect from the mains before filling the machine. Only use water-based fluids. We
recommend high-quality Eurolite fluids. Never add flammable liquids. If fluid gets inside the machine,
have it checked by skilled personnel before it is operated.
Unscrew the tank cap and fill the tank with fog fluid. Tightly close the tank again.

Placing the unit

• Remove all packing materials from the shipping box. Make sure that there are no packing remnants at the fog
output nozzle.
• Install the device in a well-ventilated area. The operation in an insufficiently ventilated room can lead to a
condensation of the fog fluid. The resulting slippery surface can cause accidents.
• To prevent overheating the device, ensure that the ventilation slits are not covered and that air can circulate
freely.
• Keep a minimum distance of 20 cm around and above the device.
• Only install the fog machine on scratch resistant and water resistant surfaces (inclination angle max. 15°).
• Do not orientate the escape nozzle directly in the direction of the audience's eyes. In order to create a good
effect, there should be a distance between the device and the audience of at least 1.5 m.
• All fog machines develop condensation around the output nozzle. Because this may result in some moisture
accumulation on the surface below the output nozzle, consider this condensation when installing your unit.

OPERATING ELEMENTS AND CONNECTIONS

MENU
Tank
Fluid hose
Display and operating buttons
5-pin XLR connectors
3-pin XLR connectors
ENTER
TIMER VOLUME STOP
DMX
OUT IN
BREAKER POWER IN
8A/250V 230V~ 50Hz
1350W

SETUP

WARNING!
17 • EN
N-1 0 3
Tour Fogger
Circuit breaker
Power output
Ventilation slits
Output nozzle
HOT NOZZLE!