Master/Slave Operation; Operation; Stand Alone Mode; Control Board - EuroLite 52202179 Bedienungsanleitung

Only use a DMX-cable and 3-pin, or 5-pin, XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected. Not suitable as signal
splitter!
Caution: At the last fixture, the DMX-cable has to be terminated. Plug the terminator with a 120
between Signal (–) and Signal (+) in the DMX-output of the last fixture.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set <Mast for the master device, as described in chapter Control Board. Set <Slav for all slave devices.
Please see further instructions under Control Board.

OPERATION

After you connected the DMX Megastrobe 3000 to the mains, it starts running and the red power indicator,
lights up (see under Overview).
The LC display lights up and you can choose the desired mode via the buttons MENU, ENTER, UP and
DOWN.
The device has two operating modes. It can be operated in Stand Alone mode via LC display with operating
buttons or in DMX-controlled mode via a lighting controller.

Stand Alone Mode

In the Stand Alone mode, the device can be used without a controller. Disconnect the device from the
controller.

Control Board

The Control Board offers several features: you can easily set the starting address, run the pre-programmed
program or select a DMX channel mode.
MENU UP DOWN ENTER
The main menu is accessed by pressing MENU until the display is lit. Browse
through the menu by pressing UP or DOWN. Press ENTER in order to select the
desired menu. You can change the selection by pressing UP or DOWN. Press
23/28
Ω
resistor
00101682, Version 1.0