Herunterladen Inhalt Inhalt Diese Seite drucken

Operation - EuroLite DYNAMIC FOG 600 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für DYNAMIC FOG 600:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Operating conditions
Prior to transportation, allow the machine to cool down and completely empty the tank.
Never operate the fog machine without fog fluid. Fire hazard due to overheating! Besides, the unit may
be damaged.
During operation smoke emission may stop. In this case the device is heating up again. After a short
period, the machine will be ready to emit fog again. This process guarantees an appropriate
vaporization temperature and the best fog emission possible. The temperature is regulated by a high-
quality thermostat.
1
Switch on the machine with the power switch (lights up). The fog machine will heat up for
approx. 100 seconds. While the unit is warming up, fog output will not be possible yet.
2
Once the warm-up process is completed, the green control indicator on the remote
control will light up. To activate the fog output, press the green button on the remote
control. While this switch is kept pressed, the unit will emit the maximum amount of fog.
As soon as you release the button, the fog output will stop.
3
After operation, switch off the machine with the power switch.
Notes
• All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so after
being turned off.
• All fog machines have a recycling period after long bursts when the machine will shut itself down for a short
period in order to heat up again. During this time no fog can be produced.
• If you experience low output, pump noise or no output at all, disconnect from mains immediately. Check the fluid
level, the external fuse, the thermo fuse and the power supply. If all of the above appears to be ok, reconnect the
unit again. If fog does not come out after holding the MANUAL button for 30 seconds, check the tube attached to
the tank to make sure there is fluid going through it. If you are unable to determine the cause of the problem, do
not simply continue pushing the button, as this may damage the unit. Return the machine to your dealer.

OPERATION

CAUTION!
17 • EN

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis