Observe room temperature
The appliance is designed for a specific climatic class.
Irrespective of the climatic class, the appliance can be
operated at the following room temperatures.
The climatic class can be found on the rating plate at the
bottom left hand side in the appliance.
Climate class
SN
N
ST
T
Ventilation
Conduction of the heated air must not be obstructed 13.
Otherwise, the refrigerating unit must work harder.
This increases power consumption.
Therefore: Never cover or block ventilation opening!
Switching on the appliance
Switch on the appliance with the main switch 5.
A warning signal sounds and alarm button 1 flashes.
Press alarm button 1 to switch off the warning signal.
The alarm button is lit and the temperature displays flash
until the appliance has reached the set temperatures.
Interior light in refrigerator compartment is switched on
when the door is open.
Operating tips
While the refrigerating unit is running, beads of water
or hoarfrost form at the back of the refrigerator
compartment. This is quite normal. It is not necessary
to scrape off the frost or wipe off the beads of water.
The rear panel defrosts automatically. The condensation
flows into the evaporation area of the appliance via the
condensation channels and the drainage hole.
26
Ambient temperature
+10 °C to 32 °C
+16 °C to 32 °C
+16 °C to 38 °C
+16 °C to 43 °C
Selecting the temperature
Refrigerator compartment
(can be selected from +2 °C to +8 °C)
Keep pressing temperature selection button 3 until the
required refrigerator compartment temperature is set.
The value last selected is stored.
The set temperature is indicated on display 4.
We recommend a setting of +4 °C.
Perishable food should not be stored warmer than +4 °C.
Door warning signal
Switching off the door warning signal
Press the alarm button 1, to switch off the warning signal.
The door warning signal switches on if the appliance door
is left open for longer than two minutes.