Reattaching The Stand - Pioneer PDP-4270XA Bedienungsanleitung

Preparation
2 Loosen and remove the two installation bolts (2) using the
supplied hexagonal wrench.
Installation bolts (2)
(M8 x 60 mm: silver)
3 Remove the plasma television from the stand.
• Make sure to keep the installation bolts (1) and (2) that have been
removed as they are reused when attaching the stand to the
plasma television.
Note
• Be sure to install the plasma television in a flat, stable location.

Reattaching the stand.

1 Fit the stand's support columns to the bottom of the plasma
television as indicated by the arrows, then slowly insert them
vertically.
• Be extremely careful not to insert the support columns of the stand
into any part of the plasma television other than the stand insertion
slots. Doing so might damage the plasma television panel or its
ports or result in warping of the stand.
Line up the column supports with
the bottom of the plasma
television, as indicated in the
accompanying diagram.
2 Attach the plasma television at the points indicated by the
arrows and tighten the installation bolts (2) firmly using the
supplied hexagonal wrench.
Installation bolts (2)
(M8 x 60 mm: silver)
3 Tighten the installation bolts (1) firmly using the supplied
hexagonal wrench.
Installation bolts (1)
(M8 x 30 mm: silver)
Note
• Be sure to install the plasma television in a flat, stable location.
• Insert the screws into the holes vertically and do not tighten them
with more force than necessary.
05
17
En