Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Before Starting Up - Parkside 6.3 A2 Bedienungs- Und Sicherheitshinweise

Druckluft-trennschleifer
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 81
Warnings specific to the air angle grinder / Operation
faster than permitted may be
damaged irreparably.
Make sure that the parting
disc size is appropriate for the
pneumatic angle grinder and
that the parting disc fits on the
spindle.
Parting discs must be stored
and handled with care and in
accordance with the manufac-
turer's instructions.
Inspect the parting disc before
use, and discard all that have
spalled, fractured, or sustained
any other damage.
Before use, make sure that the
parting disc has been fitted
correctly and tightened secure-
ly, and let the device run idle
for thirty seconds in a safe
place. Stop the machine imme-
diately there are considerable
vibrations or defects. If this is
the case, examine the devices
and identify the cause.
Do not use separate adapters
or adapter bushes: use instead
parting discs with a larger
hole diameter.
Always use the recommend-
ed guard supplied with the
pneumatic angle grinder. The
opening in the guard must
face away from the operator.
Do not use angle grinders for
face cutting.
16
GB
The parting disc continues
rotating even after the device
has been switched OFF. Af-
ter switching OFF, the device
may not be put down until the
parting disc has come to a
complete stop. This precaution-
ary measure serves to prevent
not only serious accidents, but
also dust and chips from being
sucked into the devices.
z Operation
z Before starting up
Fit the parting disc
1. Disconnect the compressed air supply
from the compressed air connection
2. Use the assembly key
dle in place, at the same time loosening
the hex screw and flange with the Allen
key
8
.
3. Fit the new parting disc
the spindle. Use the Allen key
en firmly the Allen screws. Check that the
parting disc has been fitted correctly and
can rotate without hindrance!
Compressed air connection
Trigger arm
Switch ON guard
1
.
7
to lock the spin-
6
and flange on
8
to tight-
Protective cowl
Hex screw
Flange
Spindle
75 mm parting disc

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis