Replacing Water In The Cooling Tank - Klarstein Skal Bedienungsanleitung

REPLACING WATER IN THE COOLING TANK

It is recommended replacing the water inside the cavity once each week. (No need to
replace the water for each beer keg, one week one time recommended).
Open the drain switch, water flow into the
S-shape drainpipe from this end.
Water flow into drip tray from this end.
1. Open the drain switch to drain out the water from the cavity into the drip tray. Make
sure the drip tray is fit into the notch to avoid water flow to the desk; the drip tray
can load 450 ml water;
2. After all water drain out, close the drain switch and put 800 ml fresh water into the
cavity.
3. Open the drain switch (drag the switch forward to 90 degree angle), and drain
out the water inside the cavity to drip tray, and need twice to drain out the water.
Note: clean water is necessary; make sure the drip tray is fit into the notch
to avoid water flow to the desk; the drip tray can load 450 ml water.
Move the drain switch to
horizon- tal line, will start to
drain water
Drip tray
EN
35