Self-Learning Mode With Smooth Stop; Manual Adjustment Of End Points; Initial Installation - RADEMACHER RolloTube S-line DuoFern Original - Betriebs- Und Montageanleitung

9. Self-learning mode with smooth stop

The RolloTube S-line DuoFern is delivered from the
factory in self-learning mode with a smooth stop
and can be put into operation immediately after the
electrical connection.
The roller shutter may run into the roller shutter
box in self-learning mode and be damaged with-
out stoppers or an end rail.
◆ Always fit two stoppers or an end rail to the roller
shutter (17), see page 55 / 56.
◆ Never dismantle the mechanical stoppers or the
end rail from the final roller shutter slat.

10. Manual adjustment of end points

You can also adjust the end points manually
if required:
◆ Manual adjustment of the upper and lower end
point, e.g. during the initial installation.
◆ Manual adjustment of an end point in combina-
tion with the self-learning mode.
When using as an awning drive:
You must adjust the lower end point manually
when using the RolloTube S-line DuoFern as an
awning drive.
The upper end position can then be adjusted in
self-learning mode.

Initial installation

For initial installation, the roller shutter engineer
can carry out the end point setting with the help of
the set button (11) on the motor or with a commer-
cially available universal setting cable (21).
In order to do so, follow the more
detailed information provided in the
operating manual of the respective ac-
cessories.
Subsequent modification of the end points with
external controllers
If you want to subsequently modify the end points of
your tubular motor, you can adjust these with your
roller shutter controller (e.g. Troll Comfort).
62
ATTENTION!
1.
Switch on the mains power supply.
The RolloTube S-line DuoFern is ready for opera-
tion immediately.
2.
Move the roller shutter up and down.
▲ ▼
The end positions for the smooth stop
are automatically learned during the
first run cycles.
3.
Subsequently check the direction of travel of the
roller shutter, if the RolloTube S-line DuoFern is
being operated using a switch or button.
Switch the lines for the rotation direction if the
direction of travel is wrong, see connection dia-
grams [ 30 / 31 ] on pages 59 / 60.
WARNING! WARNING!
Risk of fatal injury (electric shock) due to tear-
ing off the motor cable (15).
◆ Ensure that the motor cable (15) is not taken up
by the winding shaft (5) or torn off during the
setting process.
Important conditions for adjusting
the end points and for safe operation
◆ End points must be set in order to switch off the
motor when they are reached for both directions
of travel, up (▲)/down (▼).
◆ The tubular motor must be fully installed.
◆ There must be a suitably fixed limit (e.g. a win-
dow sill) in the area of the lower end point if the
end point is to be set automatically.
CAUTION!
Risk of crushing injuries to the hand when work-
ing with the roller shutter box open.
◆ Never reach into the area of the winding shaft
when the motor is running.
ATTENTION!
The roller shutter may be damaged in case of
incorrect manual adjustment of the end points.
◆ Never dismantle the mechanical stoppers or the
end rail from the final roller shutter slat.
◆ Do not allow the shutter to knock against the
mechanical stoppers and maintain a safety gap
of 2 - 3 cm.
EN