Mounting Into The Counter Bearing (1); Mounting The Roller Shutter (17); Mounting The Roller Shutter With Rigid Shaft Connectors - RADEMACHER RolloTube S-line DuoFern Original - Betriebs- Und Montageanleitung

7.11 Mounting the motor into the bearings

7.11.3 Mounting into the counter bearing (1)

1.
Insert the other end of the winding shaft (5)
with the ball bearing (2) into the counter bearing (1).
2.
In the event that you are using a different drive
bearing than the RADEMACHER click bearing (13),
you may need to secure the drive with a secondary
cotter pin.
3.
Correct any slight inaccuracies in size by means of
sliding the roller capsule (4) in or out.
The roller capsule (4) must be inserted at
i
least 2/3 of its length into the winding
shaft (5).
Make sure that there is sufficient space in
the axle length to ensure ease of move-
ment.
4.
Finally, secure the roller capsule (4) with a screw.

7.12 Mounting the roller shutter (17)

The roller shutter can be mounted with both rigid
shaft connectors and ties.
ATTENTION!
The roller shutter may run into the roller shutter
box in self-learning mode and be damaged with-
out stoppers or an end rail.
◆ Always fit two stoppers or an
end-rail to the roller shutter (17).

7.12.1 Mounting the roller shutter with rigid shaft connectors

Determine the number of rigid shaft connectors required
Mount at least two rigid shaft connectors per roller shutter on both ends of the corresponding octagonal
i
shaft. The number of rigid shaft connectors may vary from the following recommendation, depending on
the operating conditions.
0 mm - 1400 mm
800 mm
Recommendation: Mount an additional rigid shaft connector every 800 mm.
Roller shutters width / minimum number:
(1410 mm - 2350 mm)
(2 x )
800 mm
20
(4)
(1)
(2)
ATTENTION!
◆ Never drill or insert screws in the area of the drive
(9) in order to secure the roller shutter (17).
(3 x )
(3 x )
800 mm
EN
(5)
Drilling and inserting
screws in the area of the
drive will cause the drive
to be damaged.
(2350 mm - 3300 mm)
(4 x )
55