With Ties; Mounting Roller Shutter Stoppers Or An End Rail - RADEMACHER RolloTube S-line DuoFern Original - Betriebs- Und Montageanleitung

7.12 Mounting the roller shutter (17)
1.
Select the shaft connector type required of the
correct length. *
Incorrectly selected lengths can lead to
malfunctions. *
2.
Mount the shaft connectors (6) at the winding
shaft (5). *
* In order to do so, follow the informa-
tion provided in the operating manual
for shaft connectors.
3.
Slide the retainer profile for each shaft connector (6)
onto the uppermost slat of the roller shutter (17).
4.
Subsequently slide each retainer profile over a
shaft connector (6).
7.12.2 Mounting the roller shutter with ties
1.
Slide the ties onto the uppermost
slat of the roller shutter.
Place a tie every 40 cm into the rectangular holes
of the winding shaft.
For SW40 winding shafts (with external groove),
use suspension clamps in order to mount the ties.

7.12.3 Mounting roller shutter stoppers or an end rail

1.
Finally, mount two roller shutter stoppers (20) or
an end rail onto the lowermost slat or rail of the
roller shutter (17).
Otherwise, the upper end point must be learned
manually.
56
ATTENTION!
21
(6)
(5)
22
(17)
23
24
EN
SW40
(17)
(20)