Controlling The Tubular Motor Using A 1-Pole Button (Closer); Parallel Connection Of Several Motors - RADEMACHER RolloTube S-line DuoFern Original - Betriebs- Und Montageanleitung

8.3 Electrical connection of the tubular motor

8.3.3 Controlling the tubular motor using a 1-pole button (closer)

Legend
= Set button (11)
(a)
= 1-pole button
(b)
= Mains 230 V/50 Hz
(c)
= Socket box
(d)
Pin assignment
= PE
(e)
= N
(f)
= L
(g)
=
(h)
=
(i)
i Once the button has been connected
the function must be activated on the
RolloTube S-line DuoFern.
Activating the '1-pole button' function
1.
Tap the button 4 x briefly and press and hold the
5th time.
2.
The connected tubular motor will acknowledge
this with a slight movement, and the function is
activated.

8.3.4 Parallel connection of several motors

It is possible to connect numerous RADEMACHER
tubular motors in parallel. The number of motors to
be connected in parallel is dependent on the capacity
of the switchgear and circuit-breakers.
The end points must be set at each indi-
vidual motor prior to parallel connection.
Please refer to the respective operating
manual.
It is not possible to control individual
i
motors if the equipment is connected in
parallel.
Parallel connection with Venetian blind
switches or Venetian blind buttons
Up to five motors can be switched in parallel with
RADEMACHER Venetian blind switches or Venetian
blind buttons.
Parallel connection with RADEMACHER
controllers (e.g. Troll Comfort)
Please refer to the technical specifications for the
respective number of tubular motors that can be
connected in parallel.
60
green / yellow
blue
grey (continuous phase )
black (direction of travel 1)
brown (direction of travel 2)
31
(a)
5
(b) (d)
3
(c)
The switching sequence is as follows:
up / stop / down / stop etc.
Deactivating the '1-pole button' function
Repeat the steps 1. and 2.
Installation example
32
5
5
(a)
5
(b)
3
(c)
Legend
= Junction box
(a)
= Controller, e.g. 1-pole switch / button
(b)
= Mains 230 V / 50 Hz
(c)
EN
or
(e) (f) (g) (h) (i)
L
N
PE
5 5
5