Intended Use / Operational Conditions; Improper Use; Required Expert Knowledge Of The Installer - RADEMACHER RolloTube S-line DuoFern Original - Betriebs- Und Montageanleitung

i

3.1 Intended use / operational conditions

Only use the tubular motors for opening and closing
standard flat roller shutters and awnings.
The use of the wrong tubular motors or compo-
nents can lead to property damage.
◆ The motor cable must therefore be fitted with a
suitable empty tube up to the respective junction
box under observation of local electrical regula-
tions, if installed outside.
◆ Only use the manufacturer's original parts and
accessories.
◆ Only use tubular motors which correspond to
the local conditions in terms of their power.
Incorrectly dimensioned tubular motors can lead
to damage:
> An insufficiently dimensioned tubular motor
can be damaged due to overloading.
> An excessively dimensioned tubular motor
can, for example, cause damage to the roller
shutter or roller shutter box in self-learning
mode.
◆ Consult a specialist retailer when selecting a
tubular motor and observe the corresponding
tractive force specifications on our website:
www.rademacher.de
i

3.2 Improper use

Using the RolloTube S-line DuoFern for purposes
other than previously mentioned is impermissible.
Never use the tubular motor in systems with in-
creased safety-relevant requirements or where
there is an increased risk of accidents.
◆ Applications of this kind require additional safety
equipment. Observe the respective statutory
regulations for the installation of such systems.
Never use the tubular motor in continuous opera-
tion. Doing so will cause serious damage.
Never use the tubular motor for shutters with
openings of ≥ 50 mm in diameter.
i

3.3 Required expert knowledge of the installer

The installation, electrical connection and main-
tenance must be carried out by a qualified person
with appropriate training or by a specialist roller
shutter firm in accordance with the instructions in
this manual.
Operating conditions
◆ A 230 V / 50 Hz power supply, together with a site-
provided isolating device (fuse) must be perma-
nently available for the electrical connection at the
installation location.
◆ The roller shutter must run up and down smoothly.
It should not jam.
◆ Installation and operation of the RolloTube S-line
DuoFern is only permitted for those systems and
devices where a malfunction in the transmitter or
receiver would not cause a danger to personnel
or property or where this risk is already covered
by other safety equipment.
Radio systems which transmit on the
i
same frequency can cause interference.
Operating conditions for the self-learning
operation
◆ The roller shutter must be fitted with stoppers or
an end-rail, see page 56.
◆ Otherwise, the end points must be set manually
in the conventional way, see page 62 et seq.
Never use the DuoFern radio system and its
components for the remote control of applianc-
es and systems with increased safety-relevant
requirements or where there is an accident risk.
◆ Applications of this kind require additional safe-
ty equipment. Observe the respective statutory
regulations for the installation of such systems.
EN
41