Important Installation Instructions; Installation Of The Tubular Motor - RADEMACHER RolloTube S-line DuoFern Original - Betriebs- Und Montageanleitung

7. Important installation instructions

Preparation for installation
◆ Check that the voltage / frequency on the type
plate corresponds to local mains conditions prior
to installation.
◆ You must remove or deactivate all cables and
equipment not required for operation of the
equipment prior to installation of the tubular
motor.
◆ Moving drive parts to be operated at a height
under 2.5 m from the floor must be protected.
◆ If the tubular motor is to be controlled with a
switch with a default OFF pre-setting, then the
switch is to be positioned in the line of sight of the
tubular motor and at a height of at least 1.5 m.
◆ The cover of the roller shutter box must be freely
accessible and removable without damaging it.
◆ Never dismantle the stoppers from the final
roller shutter slat.
Otherwise the roller shutter may slip through
into the roller shutter box and be damaged.
Risk of fatal injury from crushing in the event of
operation without set end points.
◆ The end points must be set in order to ensure safe
operation. In order to do so, please refer to the cor-
responding chapter in this manual on page 62.
Incorrect installation can lead to injuries
(impact injuries and contusions).
◆ The motor can eject from the drive bearing in the
event of incorrect installation/fastening. Fasten the
tubular motor with the securing devices provided.

7.1 Installation of the tubular motor

The following installation instructions apply to
standard installation situations in combination with
RADEMACHER tubular motors and accessories.
The drive head (12) of the motor can be installed
on either the right or left side of the roller shutter
box. These instructions depict the installation on the
right-hand side.
48
Installing the tubular motor at an angle can cause
the tubular motor or roller shutter to be damaged.
For example, a roller shutter wound at an angle
can block the drive and cause damage.
◆ Always ensure that the tubular motors and bear-
ings are mounted horizontally.
◆ Please ensure that the winding shaft (5) and the
roller shutter (17) can move down easily and freely
after installation is complete.
◆ The roller shutter (17) may not run over the bear-
ing, the roller capsule (4) or the drive head (12)
during operation.
◆ Ensure that the winding shaft (5) and the rigid
shaft connectors (6) do not touch the drive (9).
They may not rub against the tubular motor (9)
during operation.
For automatically actuated awnings:
◆ A minimum gap of 0.4 m to other parts in the
area must be maintained when the awning is fully
extended.
◆ Awnings used in an awning system must maintain
a minimum height of 1.8 m.
Incorrectly dimensioned drives and counter
bearings can cause the roller shutter system to
be damaged.
◆ Only use original bearings supplied by the manu-
facturer. Third-party drives and counter bearings
must be selected in accordance with the torque
specifications of the respective tubular motors.
Required minimum width for the roller shutter
box:
Tubular motor type:
Minimum width approx.:
EN
Small Medium
56 cm 67 cm