Operation Using A Roller Shutter Switch; Jog Mode Using A 1-Pole Button; Activating The Fly Screen Door Protection; Activating Log-On Mode Using The Duofern Radio Code - RADEMACHER RolloTube S-line DuoFern Original - Betriebs- Und Montageanleitung

i

6.6 Operation using a roller shutter switch

The RolloTube S-line DuoFern can be controlled on
site using a roller shutter switch.
i

6.7 Jog mode using a 1-pole button

The RolloTube S-line DuoFern can also be con-
trolled on site using a 1-pole button.
Activating the function
The function is deactivated in the factory settings;
once the button has been connected, the function
must first be activated at the tubular motor, see
page 60.
The function can be deactivated again as required.
i

6.8 Activating the fly screen door protection

In order to protect, for example, an outward-open-
ing fly screen door you can also activate the
'Fly screen door protection' function.
The tubular motor stops and automatically moves
briefly in the opposite direction (reversing) in the
event that the roller shutter hits the fly screen door
while closing.
i

6.9 Activating log-on mode using the DuoFern radio code

The RolloTube S-line DuoFern can be set to log-
on mode in combination with a HomePilot® or a
DuoFern manual central operating unit by entering
its radio code, in order to activate other DuoFern
devices (e.g. DuoFern manual transmitter).
Time window for activation via DuoFern
radio code
After switching on the power supply, the radio code
is active for a maximum of 2 hours. Once this time has
elapsed, activation using the radio code is no longer
possible. Briefly disconnect the RolloTube S-line Du-
oFern from the mains to reactivate the time window.
By activating the up or down direction on the
switch the shutter will continue to move until it
reaches the selected end point. By deactivating
the specified direction of travel the motor can be
stopped at the desired position.
Switching sequence on the button
up / stop / down / stop etc.
Requirement for correct functionality:
The catch must be mounted with the freewheel
mechanism (see fig. 8, page 51), original factory
settings.
Activating the function via HomePilot®
The function is deactivated in the factory settings
and can be reactivated using HomePilot® when
required.
he DuoFern radio code can be found on the
enclosed label
It is imperative that you store the en-
i
closed label safely e.g. by fixing it to the
cover sheet of these instructions.
This means that you will still be able to
access log-on mode for the RolloTube
S-line DuoFern without having to open
the roller shutter system.
EN
Example:
47