Mounting The Catch (8) With The Freewheel Mechanism; Mounting The Catch (8) Without The Freewheel Mechanism - RADEMACHER RolloTube S-line DuoFern Original - Betriebs- Und Montageanleitung

7.6 Mounting the catch (8) with the freewheel mechanism

If the tubular motor is to be operated with the self-learning end point setting and obstacle detection, then
i
the catch (8) must be mounted with the freewheel mechanism (original factory settings).
1.
Slide the catch (8) onto the drive adapter (19)
so that it can free-wheel and so that it engages
behind the retaining clip (7).
Free-wheeling is given if the catch (8) can be easily
turned back and forth.

7.7 Mounting the catch (8) without the freewheel mechanism

If the catch (8) is mounted without the freewheel mechanism, then the tubular motor will work without
i
obstacle detection. Rigid shaft connectors are then required for the self-learning detection of the lower
end point.
It may be necessary to mount the catch (8) without the freewheel mechanism for very lightweight roller
shutters or for roller shutters which do not drop easily, in order to avoid premature switch-off.
1.
Slide the catch (8) onto the drive adapter (19) so
that it cannot free-wheel and so that it engages
behind the retaining clip (7).
8
(8)
9
(8)
EN
(19)
(7)
(19)
51