Safe Cable Routing By Fixing The Plug Connection; Connecting The Motor Cable (15) - RADEMACHER RolloTube S-line DuoFern Original - Betriebs- Und Montageanleitung

8.1 Safe cable routing by fixing the plug connection

Connect the motor cable of the RolloTube S-line
DuoFern to the connecting cable supplied and to
the mains or the desired controller (roller shutter
switch/button or Troll Comfort etc.).
25
Connecting cable supplied.

8.2 Connecting the motor cable (15)

1.
Connect the motor cable (15) to the connecting
cable supplied by means of a connector and make
the connection according to the following wiring
configuration.
Colour scale for the motor leads (15)
L1 =
L2 =
N
= neutral terminal
L
= continuous phase
PE = earth
11 = Set button on tubular motor
* The actual direction of travel of the
i
tubular motor and the roller shutter
depends on the direction of installa-
tion and the wiring of the tubular motor.
Shortening the motor cable (15) can
i
restrict the radio range. The antenna is
also integrated in the motor cable.
58
(black) *
(brown) *
(blue)
(grey)
(green / yellow)
The plug connection can be fixed to the drive bear-
ing if required to secure the cable.
Fixing the plug connection, for example, by
screwing to plastic bearings:
26
Fixing the plug connection by clamping to the
retaining spring of a click drive bearing:
27
The retaining spring (14) should be rotated 90° to
be plugged in and re-engaged.
28
(11)
(15)
Note about releasing the plug connection
Use an appropriate tool (e.g. a small screwdriver) to
loosen the plug connection.
EN
L1
L2
L
N
PE