FLORABEST FRTA 20 A1 Originalbetriebsanleitung Seite 10

GB
l) Never install metallic cutting
elements.
m) Before commissioning and after
any impacts, check for signs of
wear and damages, and have
any necessary repairs performed.
n) Never use the machine with
damaged or missing protective
equipment.
o) Children and persons with limi-
ted physical, sensory or mental
capabilities or inadequate
experience and knowledge, or
persons who are not familiar
with the instructions, should
never be allowed to use the
machine! Local regulations may
specify an age limit for the user.
p) Avoid an abnormal body po-
sture. Ensure secure footing at
all times to maintain balance
when working on slopes.
q) Go slowly. Do not walk with the
device in your hand.
r) Always wear sturdy shoes and
long trousers during operation
of the machine.
s) In the case of an accident
or malfunction during
operation, the device must
be switched off immedia-
tely. Injuries must be pro-
perly treated or medical
assistance sought. Read
the „Trouble shooting" section
to correct any malfunctions or
contact our Service Centre.
4) POWER TOOL USE
AND CARE
a) Do not force the power
tool. Use the correct power
tool for your application.
10
The correct power tool will do
the job better and safer at the
rate for which it was designed.
b) Do not use the power tool
if the switch does not turn
it on and off. Any power tool
that cannot be controlled with
the switch is dangerous and
must be repaired.
c) Disconnect the plug from
the power source and/or
the battery pack from the
power tool before making
any adjust -ments, chang-
ing accessories, or storing
power tools. Such preventive
safety measures reduce the risk
of starting the power tool acci-
dentaIly.
d) Store idle power tools out
of the reach of children
and do not allow persons
unfamiliar with the power
tool or these instructions
to operate the power tool.
Power tools are dangerous in
the hands of untrained users.
e) Maintain power tools.
Check for misalignment or
binding of moving parts,
breakage of parts and any
other condition that may
affect the power tool's op-
eration. If damaged, have the
power tool repaired before use.
Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp
and clean. Properly main-
tained cutting tools with sharp
cutting edges are less Iikely to
bind and are easier to control.
g) Use the power tool, acces-
sories and tool bits etc. in