Operation; Start-Up; Tub Filler / Shower Diverter; Maintenance And Cleaning - Miomare 297633 Montage-, Bedienungs- Und Sicherheitshinweise

Installation / Operation / Maintenance and Cleaning
Connect a standard shower hose to the shower
connector .
8
Connect a standard shower head to the
shower hose.
Note: Also refer to the assembly instructions for
the accessories.

Operation

Start-up

After the initial commissioning, carefully check all
connections for leaks.
Check the operation of the fitting. To do so,
swing the handle
16
tions.
Note: the fitting features an LED light. The LED is lit
through an integrated turbine (without batteries). The
LED colour changes automatically based on the water
temperature through an integrated temperature
sensor:
· up to approx. 33°C blue,
· from approx. 33-39°C green,
· over approx. 39°C red,
· over approx. 53°C flashing red
Open the main water supply.
Lift the handle and swing it to the right or
16
left in order to regulate the speed or tempera-
ture of the water.
Hot water:
Swing the handle to the left.
16
Cold water:
Swing the handle to the right.
16

Tub filler / shower diverter

Manually switch between the tub filler
function by lifting and lowering the diverter
8 GB/IE/NI
into all permissible posi-
to shower
10
.
7
Tub mixer:
Lower diverter .
7
Shower function:
Lift diverter .
7
Note: switching manually means: when turning
the water off with the shower function activated, the
shower function will remain on. When starting the
water again, the shower function will remain active
until it is switched to tub filler.

Maintenance and Cleaning

Maintaining and
cleaning the tap
Please note that sanitary taps require special care
and attention. Therefore, please follow the instructions:
When cleaning, never use petrol, solvents,
aggressive cleansers or hard cleaning brushes
etc. These could damage the surface of the
product.
Dry your fitting with a cloth after every use to
prevent any lime deposits.
Clean the product with a damp, soft cloth and
a mild cleaning agent if required.
Non-observance of the above care advice can be
expected to result in damage to the surfaces of the
product. This will inevitably invalidate the guarantee.

Replacing the LED insert

If the LED lamps fail to light, the LED insert may be
replaced.
LED life: approx. 10,000 operating hours.
A new LED insert can be obtained from the speci-
fied service address.
To do so, follow these steps:
Unscrew the tub mixer
(see Fig. C1), which requires a cross-tip
6
screwdriver.
from the fitting body
10