Connecting The Fitting; Connecting Accessories (Shower Hose And Shower Head); Operation; Start-Up - Miomare Premium Montage-, Bedienungs- Und Sicherheitshinweise

CAUTION! RISK OF INJURY! Please ensure
that no parts are damaged and that all parts
are correctly assembled. Incorrect assembly
could lead to injury. Please note that washers
and gaskets are wear parts and therefore will
need to be replaced from time to time.
Damaged parts could impact safety and function.
Be sure all seals are correctly seated.
SCALDING RISK! When adjusting the hot
water temperature be sure the water tempera-
ture is not too high.
CAUTION! Be careful not to reverse the hot /
cold water plaque
The correct position is:
left = red (hot water),
right = blue (cold water).
CAUTION! DAMAGE TO THE ARTICLE!
Please have all installations performed by skilled
individuals.
Please note that the seals are wear parts and
must be changed from time to time.
Any leakage or sudden escape of water can
cause considerable damage to buildings and
property. All connections must therefore be
checked carefully to ensure that they are tight.
Familiarise yourself prior to installation with all
local conditions, e.g. water connections and
shut-off device.
The product is only suitable for use in rooms in
which a temperature above 0 °C is maintained.
Installation
Note: Familiarise yourself with the product prior to
assembly. Carefully read the following assembly in-
structions and safety advice. In the event of incorrect
installation, all warranty claims – particularly in
relation to subsequent damage – are excluded.
CAUTION! Before you start installation turn
off the water supply at the mains. Otherwise
there is a danger of injury and / or damage to
the product.
.
2
Safety information / Installation / Operation

Connecting the fitting

Note: this step requires an SW 30 mm open-end
spanner and sealing tape.
Note: cover any parts which will be screwed with
a damp cloth or plastic clamps. This will prevent
scratches.
Follow these steps:
Wrap sealing tape around the roughened
threaded part (½ thread) of the S-connectors
Note: sealing tape not included.
Screw the S-connectors
threaded parts into the wall connectors.
Horizontally align the screwed in S-connectors
with the spacing guide for the fitting.
By hand, tightly screw the caps
S - connectors
Insert the seals
screw the fitting body
onto the S-connectors
Connecting accessories (shower
hose and shower head)
Note: Shower hose and shower head are not in-
cluded in delivery.
Note: cover any parts which will be screwed with
a damp cloth or plastic clamps. This will prevent
scratches.
Connect a standard shower hose to the shower
connector
8
Connect a standard shower head to the shower
hose.
Note: Also refer to the assembly instructions for
the accessories.

Operation

Start-up

After the initial commissioning, carefully check all
connections for leaks.
with the sealed
15
onto the
13
to the wall.
15
into the swivel nuts
12
with the swivel nuts
7
.
15
.
.
15
15
and
9
9
GB 19