Operating Instructions; Live Screen - RIDGID micro CA-300 Bedienungsanleitung

and imager head are waterproof to a
depth of 10' (3 m). Greater depths may
cause leakage into the cable and im-
ager and cause electric shock or dam-
age the equipment. The handheld dis-
play unit is water resistant (IP65) but
should not be submerged in water.
• Determine if any chemicals are pres-
ent, especially in the case of drains. It is
important to understand the specific
safety measures required to work a -
round any chemicals present. Contact
the chemical manufacturer for required
information. Chemicals may damage or
degrade the inspection camera.
• Determine the temperature of the area
and items in the area. The working
temperature of the inspection camera is
between 32 to 130°F (0 to 55°C). Use
in areas outside of this range or contact
with hotter or colder items could cause
camera damage.
• Determine if any moving parts are pres-
ent in the area to be inspected. If so,
these parts must be deactivated to pre-
vent movement during inspection to
reduce the risk of entanglement. Use
appropriate lock out procedures to pre-
vent the parts from moving during the
inspection.
If the micro CA-300 Inspection Camera is not
the correct piece of equipment for the job,
other inspection equipment is available from
RIDGID. For a complete listing of RIDGID
products, see the RIDGID catalog, online at
www.RIDGID.com or www.RIDGID.eu.
3. Make sure the micro CA-300 Inspec tion
Camera has been properly inspect ed
before each use.
4. Install the correct accessories for the ap-
plication.

Operating Instructions

WARNING
Always wear eye protection to protect
your eyes against dirt and other foreign
objects.
Follow operating instructions to reduce
micro CA-300 Inspection Camera
the risk of injury from electrical shock,
entanglement and other causes.
1. Make sure that the Inspection Camera
and work area have been properly set up
and that the work area is free of bystand -
ers and other distractions.
2. Press and hold the Power Button for two
seconds. The imager lights should come
ON, then a splash screen will appear.
This screen tells you the device is booting
up. Once the product is fully powered
up, the screen will automatically switch to
the live screen.
Figure 12 – Splash Screen
(Note: Version will change with each
firmware update.)

Live Screen

The live screen is where you will do most of
your work. A live image of what the camera
sees is displayed on the screen. You can zoom,
adjust LED brightness and take images or
video from this screen.
The screen has a status bar at the top showing
the tool mode, zoom, SD™ card icon if in-
serted, available memory and speaker/mic
ON/OFF. The bottom bar shows information
about date and time if time stamp is ON.
Figure 13 – Live Screen
When the Inspection Camera is turned ON, the
default mode is for capturing still images.
Status
Bar
Information
Bar
9