Image Adjustment; Image Capture - RIDGID micro CA-300 Bedienungsanleitung

micro CA-300 Inspection Camera
Pressing the menu button at any time will ac-
cess the menu. The menu will overlay on the
LIVE Screen. Use the right and left arrow
buttons to switch to the MODE category. Use
the up and down arrows
tween menu items and press select
sired.
Figure 14 – Screen Shot of Mode Selection
3. If the other inspection camera settings
(Time Stamp, Language, Date/Time, TV
Out, Update Firmware, Speaker/Micro -
phone, Auto Power OFF, Factory Reset)
need to be adjusted, see Menu Section.
4. Prepare the camera for inspection. The
camera cable may need to be pre-formed
or bent to properly inspect the area. Do not
try to form bends less than 5" (13 cm)
radius. This can damage cable. If inspect-
ing a dark space, turn the LEDs on before
inserting the camera or cable.
Do not use excessive force to insert or
withdraw the cable. This may result in
damage to the inspection camera or in-
spection area. Do not use the cable or im-
ager head to modify surroundings, clear
pathways or clogged areas, or as any-
thing other than an inspection device.
This may result in damage to the Inspec -
tion camera or inspection area.

Image Adjustment

Adjust LED Brightness : Pressing the right
and left arrow button
live screen) will increase or decrease the
LED brightness. A brightness indicator bar
will be displayed on the screen as you adjust
brightness.
10
to navigate be-
as de-
on the button pad (In
Figure 15 – Adjusting LED
Zoom : The micro CA-300 Inspection Camer -
a has a 2.0x digital zoom. Simply press the up
and down arrows
to zoom in or out. A zoom indicator bar will be
displayed on the screen as you adjust your
zoom.
Figure 16 – Adjusting Zoom
Image Rotation : If needed, the image/video
seen on the screen can be rotated in 90 de-
gree increments counter clockwise by press-
ing the rotate image button

Image Capture

Capturing a Still Image
While in the live screen, make sure the still
camera icon is present at the top left por-
tion of the screen. Press the shutter button to
capture the image. The save icon
mentarily appear on the screen. This indi-
cates the still image has been saved to the
internal memory or SD™ card.
Capturing a Video
While in the live screen, make sure the video
camera icon is present at the top left por-
tion of the screen. Press the shutter button to
start capturing video. When the device is
recording a video, a red outline will flash
while in the live screen
.
will mo-