Startup / Operation - BOMANN DT 248 Bedienungsanleitung

to the opposite door underside. Place the fridge
door safely aside as well.
• Tilt the appliance slightly backwards and block it
in this position. Unscrew the feet. Dismount the
lower door hinge and the door holding device.
• Attach the lower door hinge and the door holding
device at the respecively other appliance under-
side. Turn in the feet accordingly.
• Replace the appliance upright. Put on the fridge
door and fix it in its intended position.
• Turn the middle door hinge about
180° and transfer it at the opposite
appliance site. Put the hinge pin in
the hole of the fridge door and fasten the hinge.
• Put on the freezer door and fix it in its intended
position.
• Transfer the upper door hinge at the opposite
appliance side, after you have un-
screwed the hinge pin and used it
from the other hinge side. Put the
hinge pin in the hole of the freezer door and fas-
ten the hinge. Replace the hinge cover.
• Check if the doors are aligned vertically and hori-
zontally optimally so that the smooth opening and
closing of the doors is guaranteed.

Startup / Operation

Startup / Operation Startup / Operation Startup / Operation
Prior to first use Prior to first use
Prior to first use Prior to first use
CAUTION CAUTION CAUTION: : : : CAUTION
After transport, the appliance should be left standing
upright for about 4 hours before connecting to the
power supply. Nonobservance could lead to malfunc-
tion of the cooling system and causes an appliance
breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter "Cleaning and Maintenance".
Starting the appliance Starting the appliance
Starting the appliance Starting the appliance
• Connect the appliance to the power supply.
• Operate the temperature control. See also the
following section "Settings".
Settings Settings
Settings Settings
Setting [OFF] means that the appliance is in the off
state. Turn the temperature control clockwise, start-
ing from this setting; the appliance will turn on auto-
matically.
The power levels [MIN - MAX] regulates the different
values of the internal temperature.
Setting 0 Setting 0 Setting 0 Setting 0 Setting 1 Setting 1 Setting 1 Setting 1
Off state Lowest setting
(warmest inside
temperature)
Note that the temperature will change depending on
the ambient temperature, frequency of door opening
and the amount of food in the appliance.
During initial operation, turn the temperature control
to the highest setting first, until the appliance has
reached the desired operating temperature. After-
wards it is recommended to turn the control back to a
medium setting; correcting the temperature at a later
point would then be easier.
Interior light Interior light Interior light Interior light
When opening the appliance door, the interior light
will turn on automatically.
F F F F ridge ridge ridge ridge
Always store food covered or packed in order to pre-
vent drying-out and transfer of odor or taste onto
other food items. You may pack the food with e.g.
• Polyethylene plastic
bags or foil
• Plastic bowl with lid
19
Setting 7 Setting 7 Setting 7 Setting 7
Highest setting
(coldest inside
temperature)
• Special plastic covers
with elastic strip
• Aluminum foil