Fagor FG9-05 Bedienungsanleitung Seite 40

Open the main general gas-tap installed on the outside of the appliance.
1st Step Pilot Light Ignition
Turn the thermostat Mt control (Fig. 6) clockwise until the pilot light position
lamp will light up (Fig. 6) indicating that it is ready for the "P" pilot light to be ignited (Fig. 6).
Next, press the solenoid valve Mv control (Fig. 6), whilst turning anti-clockwise to the pilot light position
In this position, keep pressing the control until the "P" pilot light flame (Fig. 6) is permanently lit (approximately 20
seconds).
2nd Step Ignition of burners
Pressing the solenoid valve control Mv (Fig. 6), rotate to burners ignition position (Fig. 7 - P2), it is ready for the
burners to be ignited.
To ignite the burners, press and turn the thermostat "Mt" control (Fig. 6) clockwise until the required position, (Fig. 8,
P2 and P3). At this moment the "L2" lamp will light, indicating that the burners are functioning.
The required oil temperature (approximate) can be achieved turning the "Mt" control to selected position (see table 4
for temperatures, indicating the temperature corresponding to each position on the control).
When the oil in the vat reaches the selected temperature, the burners will turn off by means of the thermostat (lamp
"L2" turns off). Also, as soon as the temperature drops below the selected value, the burners will light up (switching
on the L2 lamp).
Turning the burners off
Move from the position selected on the "Mt" control to the pilot light position (Fig. 8 – P1), so that only the "P" pilot
light is on (Fig.6)
Turning the pilot light off
Move the "Mv" control to the "0" position (Fig. 8 –P0) and also move the "Mt" thermostat control to the "0" position
(Fig7. – P0)
Initial cleaning
After installing the appliance, and before filling the vat with oil, it is necessary to fill it with soapy water, which should
be left to boil for a few minutes. Next, empty the vat and rinse it as many times as necessary, to eliminate the
remains of soap.
Daily cleaning
In order for the appliance to work as new, it is advisable to follow the following instructions:
Do not use gritty and abrasive detergents for cleaning.
Do not use a water hose to clean the appliance.
It is advisable to regularly clean the inner part of the vat with soapy water that will be left to boil for a few minutes, and
then rinse it with plenty of water.
It is important that as soon as the vat has been cleaned and before filling it with oil, it be completely dry without a sign
of water.
List of spare parts
Gas valve
Burner
Pilot burner
Burner ignition
3.-MAITENANCE
Thermocouple
Thermostat
39
(Fig. 8 - P1), at this moment the "L1"
(Fig.7 - P1).