Herunterladen Diese Seite drucken

Fagor FG9-05 Bedienungsanleitung Seite 39

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 24
Pilot light conversion
To convert to NATURAL GAS, please proceed as follows: Loosen screw "A" of the Fig. 4.
The 0.25 mm injector "B" is underneath screw "A", which must be loosened and replaced by the 0.40 mm injector
supplied with the nozzles.
Turn the air regulator "C" until the flame steadies, fig 4.
To convert to TOWN GAS, the adjustment of the pilot flame will be carried out turning the adjusting screw "B" until the
flame is stable.
After adapting the equipment to another type of gas or to another pressure, other than that for which it had
been previously set, the old instructions should be replaced with the instructions for the new settings, to
enable unambiguous identification of the state of the equipment after modification.
2.-USAGE
Preliminary recommendations
It is advisable to call a qualified installer to install the appliance and if necessary, adapt it to use other types of gas.
This appliance is only for professional usage and must be used by qualified personnel.
IMPORTANT: The parts protected by the manufacturer must not be manipulated by the installer and or user.
USAGE RISKS:
You are using a fryer, do not use this appliance for anything other than what it is designed for, as its operating
components may be damage.
Frequently check the tubs' filling level.
- It if is insufficiently filled the oil may get too hot causing the appliance to overheat.
- Too much oil may cause the hot oil to spill out with the subsequent risk of burns.
Try not to fill it up with oil when the fryer is hot, as it could cause the oil to splash out.
Avoid putting wet food into the fryer or water in the oil or hot fat, as oil may splash causing serious burns.
If you are going to use solvents or inflammable clearing products to remove the possible dirt on the tub, always do so
when the fryer is cold, the control buttons off, and the gas tap closed. Once the products have been used, carefully
clean it the tub with plenty of water.
Turning the appliance on
IMPORTANT: Never start up the appliance without having previously filled the vat, otherwise overheating would
seriously damage the machine.
The oil should be filtered regularly, in order to preserve it better.
Replace the oil when it reaches the MINIMUM level (Fig. 6).
It is recommended to insert the loaded basket in the oil slowly so that the oil froth resulting from frying does not boil
over the upper part of the vat.
38

Werbung

loading